Introduction
You can use an external program to create a source that will read
data coming out of the standard output (stdout
) of this
program. Contrary to the external file decoders, data will be buffered
and played when a sufficient amount was accumulated.
The program should output data in signed 16 bits little endian PCM (s16le). Number of channels and samplerate can be specified. There is no need of any wav header in the data, though it should work too.
Basic operator
The basic operator for creating an external stream is
input.external
. Its parameters are:
buffer
: Duration of the pre-buffered data.max
: Maximum duration of the buffered data.channels
: Number of channels.samplerate
: Sample rate.restart
: Restart the process when it has exited normaly.restart_on_error
: Restart the process when it has exited with error.
The last parameter is unlabeled. It is a string containing the command that will be executed to run the external program.
Wrappers
A wrapper, input.mplayer
, is defined to use mplayer as
the external decoder. Its code is:
# Stream data from mplayer
# @category Source / Input
# @param s data URI.
# @param ~restart restart on exit.
# @param ~restart_on_error restart on exit with error.
# @param ~buffer Duration of the pre-buffered data.
# @param ~max Maximum duration of the buffered data.
def input.mplayer(~id="input.mplayer",
~restart=true,~restart_on_error=false,
~buffer=0.2,~max=10.,s) =
input.external(id=id,restart=restart,
restart_on_error=restart_on_error,
buffer=buffer,max=max,
"mplayer -really-quiet \
-ao pcm:file=/dev/stdout \
-vc null -vo null #{quote(s)} \
2>/dev/null")
end